AudioSource EQ 200 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Korektor stereo AudioSource EQ 200. AudioSource EQ 200 12 stron. Ten-band stereo graphic equalizer with spectrum analyzer display
Również dla AudioSource EQ 200: Instrukcja obsługi (4 strony), Instrukcja obsługi (7 strony), Instrukcja obsługi (5 strony)
Drukuj stronę
..Hooking It All Up
The EQ 200 should be connected through the "Tape Monitor Loop" of you receiver, integrated
amplifier, or preamplifier. Since the EQ 200 replaces the tape deck, remember to activate the "Tape
Monitor" switch on your receiver, integrated amplifier, or preamplifier - as you would when playing
your tape deck. Your tape deck can now be plugged into the back of the EQ 200.
When making or changing connections, it is always wise to unplug the power cords of your compo-
nents - or at least make sure the power is "Off", so you won't hear any unexpected "pops" during
connection of cables.
l.Connect the Tape Out or Tape Record jacks (different components use different terminology) on the
back of your receiver/integrated amplifier/preamplifier to the Audio In jacks of the EQ 200.
2. Connect the Main Out jacks of the EQ 200 into the Tape In or Tape Monitor jacks of your re-
ceiver/integrated amplifier. this completes the "loop".
3. Always make sure to engage the "Tape Monitor" button on your receiver, no matter which input
source you want to listen to. This allows the "Equalized" signal to be heard on any source material.
4. You can connect two tape decks to the EQ 200. For Tape 1, connect the Line Out or Record jacks
on your tape deck to the Tape 1 IN (play) jacks on the EQ 200. Next, connect the Line Out or Monitor
jacks on your tape deck to the Tape 1 IN (play) jacks on the EQ 200. For Tape 2, repeat this step using
the Tape 2 Ret and Tape 2 play jacks on the EQ 200.
5. You may use the "Video In" jacks on the EQ 200 to connect any high output source, such as a CD
player, tape deck, or the
audio
outputs of a VCR or laserdisc.