Audiotec Fischer HELIX Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Audiotec Fischer HELIX. Audiotec Fischer HELIX 5 stron.

Drukuj stronę

Dear Customer,

congratulations on your purchase of this high-quality

HELIX amplifier, made in Germany. The new Helix

competition series amplifiers highlights best quality,

excellent manufacturing and state-of-the-art technology.

After 24 years of experiences in the research & develop-

ment of audio products this amplifier generation sets

new standards. The attractive typical Helix design makes

this amplifier to an outstanding and top of the class pro-

duct.

We wish you many hours of enjoyment with your new

HELIX amplifier.

Yours

AUDIOTEC FISCHER Team

General installation instructions for

HELIX amplifiers

To find out how HELIX amplifiers work best for you,

read this manual carefully and follow the instructions

for installation. We guarantee that this product has been

checked for proper functioning before shipping.

Before you start installation, disconnect the car battery

at the minus pole. We would urge you to have the instal-

lation work carried out by a specialist as verification of

correct installation and connection of the unit is a prere-

quisite for warranty cover of the HELIX amplifier.

Install your amplifier at a dry location where there is suf-

ficient air circulation to ensure adequate cooling of the

equipment. For safety reasons, the amplifier must be

secured in a professional manner. This is performed by

means of four fixing screws screwed into a mounting

surface offering sufficient retention and stability.

Before drilling the holes for the screws, carefully

examine the area around the installation position and

make sure that there are no electrical cables or compo-

nents, hydraulic brake lines or any part of the petrol tank

located behind the mounting surface - otherwise these

could be damaged. You should be aware of the fact that

such components may also be concealed in the double-

skin trim panels/mouldings.

General instruction for connecting the

amplifiers

The HELIX amplifiers may only be installed in motor

vehicles which have a 12-volt minus pole connected to

the chassis ground. Any other system could cause dama-

ge to the amplifier and the electrical system of the

vehicle.

The plus cable from the battery for the complete system

should be provided with a main fuse at a distance of

max. 30 cm from the battery. The value of the fuse is

calculated from the maximum total current input of the

car audio system.

Install the cabling in a manner which precludes any dan-

ger of the leads being exposed to shear, crushing or

rupture forces. If there are sharp edges in the vicinity

(e.g. holes in the bodywork) all cables must be cushio-

ned and protected to prevent fraying.

Never lay the power supply cables adjacent to leads and

lines connecting other vehicle equipment (fan motors,

fire detection modules, gas lines etc.).

In order to ensure safe installation, use only high-quali-

ty connections and materials. Ask your dealer for high

quality accessories.

Connecting the remote lead

Connecting the battery cable

Connecting the ground cable

Fuses 4 x 20 ampere

Fuse function indication

6 - 11

Signal inputs

12 - 17

Level controls for input sensitivity

300 mV - 8 V

18 - 20

CPS-Colour Protection System

green

= in operation

yellow

= technical failure

red

= overheating

21 - 23

Switch for mono or stereo signal

Speaker terminals

front and rights

Speaker terminal

rear and right

Speaker terminal center speaker

Speaker terminal woofer

Control for subsonic filter

of woofer channel