CONTACLIP TTPCard Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka CONTACLIP TTPCard. CONTACLIP TTPCard 11 stron. Thermal transfer printer
Drukuj stronę
N° OF
FAULT DESCRIPTION
BLINKS / BEEPS
1
Printer ribbon not present
3
Print head not lowered
4
Print head not raised
Carriage not in correct
5
starting position or out of
position
Carriage not moving correctly
6
or in wrong position
System software or printer
8...11
driver malfunction
TTPCARD electronic
12.....
controller malfunction
15
RFID inlay / plate error
Green button (4): authorised user only TEST mode, accessed by pressing green button (4) for more
than 6 seconds during the initial start-up cycle, is indicated by the yellow and orange LEDs blinking
simultaneously. Inadvertent access may be cancelled by switching the TTPCard OFF and then ON
again after a few seconds.
POSSIBLE SOLUTION
Check condition of the ribbon and that it
threaded correctly. Switch TTPCard OFF and
then ON again after a few seconds.
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly. Remove any obstacles preventing full
movement of the carriage.
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
Check the printer driver and system default
settings are correct. Switch TTPCard OFF and
then ON again after a few seconds
Switch TTPCard OFF and then ON again after
a few seconds If the problem persists please
contact CONTA-CLIP,
Check if the inlay type is correct.
Deactivate plate / inlay control under the printer
settings in CONTASign Pro, or contact
CONTA-CLIP
10