CONTACLIP TTPCard Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka CONTACLIP TTPCard. CONTACLIP TTPCard 11 stron. Thermal transfer printer

4.5

Install the printer ribbon

Remove the lid, then:

1. Rotate the media guide completely downwards.

2. Extract both feed (rear) and take up (front) spindles by carefully pulling them upwards.

3. Fit the printer ribbon on to the feed spindle (rear), locating the slot in the ribbon spool fully on

to the key on the spindle. When viewed from the front of TTPCard, the key should be on the

right hand side with the lead of the ribbon underneath, facing forward.

4. Relocate the loaded feed spindle firmly into its seatings in TTPCard. Unroll sufficient ribbon to

pass under the rear guide bar and guide plate and over the template.

5. Continue unrolling the ribbon until it has passed under the front lower guide bar and is

protruding through the carriage aperture.

6. Fit the ribbon take up spool provided with TTPCard onto the take up spindle (front), locating

the slot in the spool fully on to the key on the spindle.

7. Using the carriage/template as a convenient base, position the take up spool at the end of the

protruding printer ribbon such that the white cog is on the left hand side (viewed from the

front). Ensure the ribbon is square to the spool and attach the end of it to the spool with

adhesive tape. Carefully and accurately wind a few turns of ribbon around the spool.

8. While carefully pulling ribbon through TTPCard, relocate the loaded take up spindle into its

seatings in TTPCard. Ensure the ribbon is correctly aligned on the front guide bars, without,

tears, folds or creases.

9. Rotate the media guide completely upwards, then replace the lid.

Do not operate TTPCard without the lid in place.

We recommend cleaning the print head at each ribbon replacement, using only the CONTA-CLIP

28043.0 CLEANING KIT following the procedure in section 5.1