DAPAudio D3253 Skrócona instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Głośniki DAPAudio D3253. DAPAudio D3253 12 stron.

Controlpanel

Volume

Use to adjust the input volume level for the X-15A.

2) Limiter LED

We suggest you to set the input level with the L-R level controls in such way that the LED blinks

occasionally. If the LED lights up continuously we strongly suggest you to lower the Volume control

(1).

3) Loudness Button

The loudness circuit amplifies certain frequencies in order to get a more full sound at low volumes.

Low frequency

Use to set the optimal crossover frequency for the active subwoofer connected to the low output.

5) Sattelite/ Fullrange Button

Allows you to switch the X-15A as either a satellite speaker (in combination with an additional

Subwoofer) or as a full range speaker.

6) Combo Input

The input equipped with 3 pole XLR/ jack combo socket is electronically balanced to accept the

(line) signal from any mixing console.

7) Full range XLR Output

For linking several X-15A speakers.

Ground Lift Switch

When this button is pressed, it separates the signal ground from the chassis ground, enabling you to

eliminate potential ground loops or low-frequency hum.

9) Low XLR Output

For connection of an optional subwoofer.

10)

AC Inlet With Integrated Fuse Holder

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the power switch (11) to

operate the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

11)

AC Power Switch

This is the main Power switch. Press to turn the X-15A on.

Replace the fuse only with a fuse of same specification (T4A).

Fig. 2