Contacta Loop-FSM Podręcznik użytkownika - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe Contacta Loop-FSM. Contacta Loop-FSM 5 stron. Audio frequency induction loop field strength meter
Drukuj stronę
Background Noise Level Test
After turning the meter on it comes up in the Background
Noise "A weighted" measurement mode. The display will indicate
the RMS reading on the first line and the MAX reading on the second
line. Pressing button "B" resets the MAX reading.
How to test for background noise:
When testing a new facility for background noise first turn on
all lights, fans, sound system and other electrical equipment which
is normally on when the facility is in use. Usually the loop system has
not been installed yet, however if you are certifying an installation
this test is done without the hearing loop system turned on.
Walk throughout the seating area where the loop system will
be used, holding the meter in a vertical position at the listening
plane height. The important reading will be the MAX reading, Howev-
er it is important to watch the RMS reading. If the MAX reading ex-
ceeds –32dBA (readings above –32dBA will have a lower negative
number ex. –30dBA means there is more background noise than
–35dBA), you will need to document the areas where those higher
noise levels are found.
IEC 60118-4 Notes and Requirements
The standard as revised in 2004 notes that any background
noise level lower than –47dBA will result in a excellent signal to
noise ratio, however levels below –32dBA are acceptable and do
meet the requirements of the standard. If the background noise lev-
el is above –32dBA, then the facility management should be notified
and the source of the interference found and repaired.
4
Method II - Pink noise signal Cont.
Record the RMS level readings for each of the frequencies`.
As in method I if the level does not vary by more than ±3dB the sys-
tem as installed will meet the IEC specification. This method was
requested by the field engineer so they could run the test with one
instrument without continually adjusting the frequency source. It
also makes it easy to conduct the test in more than one location.
Headphone / Full Spectrum Output
The headphone output jack serves two purposes: First it can
be used to monitor the loop program and gives you an "A Weighted"
output signal that can be listened to with standard 1/8" stereo head-
phones. To change the headphone volume slide the Use/Menu
switch to Menu and use the Mode button to advance to Headphone
Volume. Pressing the Select button advances to the volume adjust
screen where the top button raises the volume and the bottom but-
ton lowers it. Once adjusted sliding the switch back to Use will save
the setting.
A full (flat) spectrum output can be sent from this same con-
nector which could then feed a spectrum analyzer. This would show
the signal level at the various frequencies and help to both confirm
proper operation and asses the frequency and level of any interfer-
ences.
To switch from "A-Weighted" to Flat: With the meter turned
on slide the Use/Menu switch over to Menu. Press the Mode button
"A" once and you will advance to the Headphone Jack setup screen.
Then pressing the Select button "B" you can choose either A-
Weighted or Flat Spectrum.
Menu Adjustments
In the Menu mode, selected by the slide switch, the following items
can be adjusted: Backlight level, Headphone output type, Head-
phone volume, Display units (dB, mG, uT) and Power timeout (5 to
30, or none.
7