DAPAudio EVO 8 A Podręcznik - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik dla Głośniki DAPAudio EVO 8 A. DAPAudio EVO 8 A 12 stron.
Drukuj stronęEVO 8A
Names and Functions
01) LED indicators (OK/CLIP/TEMP/ERROR)
●
OK: The EVO is operating within its safety limits.
●
CLIP: It indicates distortion. In this case, decrease your source signal level until the LED turns off.
Please keep in mind that the EVO cannot correct any distortion.
●
TEMP: It indicates overheating. Turn the EVO off for 15 minutes and allow it to cool down.
Decrease your source signal level. Make sure that the device receives adequate cooling.
Turn the EVO on again and check if the problem persists.
●
ERROR: It may indicate a hardware malfunction. Turn the EVO off for 15 minutes and allow it to
cool down. Turn the EVO on again and check if the problem persists.
02) Bass control
Turn the control to adjust output's bass.
03) Treble control
Turn the control to adjust output's treble.
04) Speaker connector OUT
Connect the active EVO speaker to the passive EVO speaker, by means of the included speaker
cable.
05) Power LED indicator
The LED will light up when the device is on.
06) Volume control
Turn the control to adjust output's volume.
07) Power switch ON/OFF
Press the button to switch the device on/off.
08) Fuse 5S1,5A/250V
09) 230V AC C8 power connector IN
This connector is meant for the connection of the supplied power cable. Connect one end of the
power cable to the connector, the other end to the mains. Flick the power switch to operate the
device.
10) Line connector, balanced IN
Connect input signal (for example, from a mixer) to the speaker, by means of a speaker cable.
11) RCA line connector, unbalanced IN
Connect input signal (for example, from a mixer) to the speaker, by means of an RCA cable.
Maintenance
The DAP Audio EVO 8A requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Replacing the Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below.
01) Unplug the unit from electric power source.
02) Insert a screwdriver into the fuse holder. Turn the fuse holder counterclockwise. The fuse holder will
come out.
03) Remove the used fuse. If brown or unclear, it is burned out.
04) Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse holder. Be sure
to use a fuse of the same type and specification. See the product specification label for details.
Order code: D3693
8