DURASTEEL Cart Table w/ Cart Legs and U-Shaped Bracing Instrukcja montażu - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz DURASTEEL Cart Table w/ Cart Legs and U-Shaped Bracing. DURASTEEL Cart Table w/ Cart Legs and U-Shaped Bracing 11 stron. Wooden table
Drukuj stronę
a
Nut (A)
Nut (B)
a. Caster Assembly
Insert the caster into the leg, if the rubber part is too large for the socket, please loosen the top nut (A) by moving it counter
clockwise. Once the stem successfully inserted into the leg, please use a wrench to tighten nut (B) by moving it clockwise until
the caster is firmly secured inside the leg.
If the above way doesn't work. Please use a wrench to turn the gear looking parts either on top or below the black rubber part,
so it moves toward the rubber to squeeze and expand the rubber until it is about the same size as the feet socket. Simply insert
the caster into the feet socket. Now the caster is upside, tighten it by moving the base clockwise. Since they are about the same
size now, it will stuck inside the leg.
b
b. Turn over the completed equipment stand and it is now
ready to use.
*If you want to replace your Bullet Feet of Standard Legs to Casters, Please refer to the
instruction below:
Please use slotted screwdriver to remove bullet feet, or disassemble the table top and slide a
long pole into the opening end of leg, and then push feet until it is removed. After you remove
the bullet feet, please follow the Caster Installation Instruction above. Thank you!
c
Unlocked
c. Use the caster brakes
Push down the brake if you want to lock the caster, lift it up
if you want it unlocked. *This instruction applies to both
Top-brake casters and Side-brake casters.
5
Locked