Audiovalve ASSISTENT 100 Mark 2 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Audiovalve ASSISTENT 100 Mark 2. Audiovalve ASSISTENT 100 Mark 2 18 stron. Integrated stereo triode tube amplifier
Drukuj stronęAssistent 100 – Mark 2
integrated tube amplifier_
___________
UNPACKING & SET UP
Ideally your dealer will carry out this process for you. If you wish to unpack
and set-up the amp yourself please follow the following steps carefully.
Each ASSISTANT 100 comes in its own wooden crate and weighs 40kg
unpacked, so it is advisable to have another person assist you with the
following un-packing operations.
First remove the lid to the crate using a pozi-drive No 2 screwdriver.
The power output valves are packed individually inside the crate. Remove all
four of these and place them somewhere safe!
To remove the ASSISTANT 100 from its crate first undo the plastic wrapping. Each
person should then grab the outer rim of the Perspex top and lift the amplifier
until it can be rested on the edge of the crate. Any further lifting should be
carried out holding the bottom of the amplifier chassis. Do not lift the
amplifier using the protective grille!
We suggest you leave all packaging in the crate and re-fix the top so you
can use it again in the unlikely event that you need to return the unit under
warranty (see warranty conditions at the end of the manual) or place the
unit in storage.
Next remove the protective metal top plate and Perspex top plate assembly from the
top of the amp so you can fit the power valves. This cover is fixed to the
Perspex top plate by screws. This top plate is fixed to the amp by 4 round
smooth topped bolts, one in each corner of the top plate. To remove the
assembly, undo these bolts, not the screws.
It is possible that the driver valves already on the circuit board may have
been vibrated loose in transit, so first check that they are securely in place – if not,
push them firmly home. Once you have done this, remove the power
valves from their packing one at a time and fit them into the vacant sockets.
Take care to align the pins correctly before pushing them fully into position
otherwise the socket may be damaged requiring a return of the unit to the
factory for repair.
Once all four power valves have been installed, clean any finger marks off
them and the driver valves with a tissue or lint-free cloth and replace the top
plate assembly. This assembly is decoupled from the amplifiers chassis by
plastic washers. When you re-fit the cover do not over-tighten the knurled
nuts or the decoupling will be reduced. It is sufficient to tighten the nuts until
they touch the top plate and then tighten one half-turn more only.
The amplifier is now ready for connecting into your audio system. Experience
has shown that these amplifiers benefit from resting on a solid surface rather
than carpet. Your AudioValve dealer will be able to recommend a suitable
support that ensures adequate airflow around and through the amplifier. Do
not place this amplifier in a position where liquids or any hard objects may
accidentally enter it.
H
AVE A LOOK THAT ALL TUBE CORRECT PLACED IN THE TUBE
SOCKETS BEFORE YOU SWITCH ON THE AMP !!