Duratool D00671 Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Pistolet lutowniczy Duratool D00671. Duratool D00671 4 stron. 320w soldering & rework station
Drukuj stronęTIP REPLACEMENT
•
Replacing the tip should only be done when the iron is switched off and at room
temperature.
•
The tip can be changed or replaced by unscrewing the knurled nut barrel.
Caution: Damage could occur if the iron is left on without the tip inserted.
•
After removing the tip, blow out any remaining oxide dust that may have formed in
the tip retaining area of the barrel.
Warning: Care should be taken to avoid getting dust in your eyes.
•
Replace the tip and tighten the knurled nut barrel assembly with your fingers.
•
Pliers should only be used to tighten the nut if loosening occurs when the iron is
hot.
•
Do not over tighten the nut as the element could be damaged.
CLEANING
•
Cleaning should only be done when the power is switched off and the irons are
at room temperature. Use a damp cloth and a small amount of liquid detergent if
necessary.
•
Never submerse the hot air gun, iron or control station in liquid or allow any liquid
to enter the case.
•
Do not use any chemicals, abrasives or solvents that could damage the hot air
gun, interconnecting leads and pipe, soldering iron or the control station.
TROUBLESHOOTING
•
"ERROR" is displayed -
•
Tip will not reach set temperature - Defective heating element
•
Solder will not wet the tip -
SPECIFICATIONS
Input Voltage
Power Consumption - Hot Air Gun
Power Consumption - Soldering
Output Voltage
Temperature Range
Weight
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronics Equipment (WEEE). Any WEEE marked products must
not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details
of recycling schemes in your area.
A loose connection - check
connection of the iron to the station.
Tip temperature is too high.
Tip is badly oxidized and requires cleaning.
220-240V~50Hz
320W
60W
24V AC
160-480°C
6.28kg
4
Made in China. PR2 9PP
Man Rev 1.0