Duratool DT000472 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Elektronarzędzie Duratool DT000472. Duratool DT000472 4 stron.

Important Safety Information

Please read these instructions carefully before use and retain for future reference

• When using electrical appliances basic safety precautions should always be followed.

• Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the

appliance to the mains power supply.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the

appliance by a person responsible for their safety.

• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are

older than 8 and supervised.

• Do not operate the appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any

way.

• If the supply cord is damaged, it must be replaced by a qualified engineer in order to avoid injury or a hazard.

• Ensure there is sufficient space and ventilation around the appliance to allow the escape of heat and/or fumes.

• Do not expose to rain or moisture.

• Never place the product or part of it in water, or operate if your hands are wet.

• Soldering work must be conducted on a stable, non-combustible surface.

• Do not touch any metallic parts near the soldering tip/nozzle.

• The iron must not be left unattended while it is connected to the supply mains.

• Turn the soldering iron off and unplug it when it is not in use.

• This device must be earthed through the mains lead and plug.

What's Included

Soldering Iron

Stand

User manual

Application and Operation

Note: The first time you use the soldering iron, it may smoke slightly as the heating element dries out. This is normal and

should only last for a few minutes.

Only use for Electrical Work - Acidic solder will damage the iron tip.

• Connect the mains plug and turn on the power, the red LED on the handle will illuminate.

• Slide the switch to the first position and the iron will heat up.

• Slide the switch to the second position and the LEDs will illuminate to light the work area.

• Clean off any dirt, rust or paint on the part you wish to solder with the supplied tools.

• Heat the part with the soldering iron.

Newark.com/exclusive-brands

Farnell.com/exclusive-brands

Element14.com/exclusive-brands

Page <2>

03/04/19

V1.0