Duratuf GS63 Instrukcja montażu - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Przechowywanie na zewnątrz Duratuf GS63. Duratuf GS63 16 stron.

Drukuj stronę

ROOF ASSEMBLY

SELECT:

3 x 1.110 m Roof Sheets

1 x 1.110 m 1Pan Roof Sheets

1 x 1.725 m Spouting

1 x 1.725m Ridge

2 x 1.110 m Barges

9 x 50mm Roofing Screws

39 x Rivets

13 x 50mm Clouts

STEP 1:

• Ensure Shed is sitting level and square.

• Lay Roof Sheets on the Top Plates.

• Rivet sheets together at overlaps with 2 x rivets per join (fig.1).

STEP 2:

• Position the Roof Sheets with the back lining up with the outside

edge of the back wall cladding as in (fig.4).

• Using 4 x 50mm Clouts, predrill and nail the Roof Sheets to the Top

Plates through the ribs, at each corner, ensuring ribs on the Roof

Sheets line up with ribs on the Wall Sheets (fig.2).

STEP 3:

• Ensure the Front and Back Top Plates are straight.

• Using 9 x 50mm clouts, nail the roof sheets to the back Top Plate,

through each rib.

• Using 9 x 50mm roofing screws, screw the roof sheets to the front

Top Plate, through each rib.

STEP 4:

• Place Barge Flashings on roof at end of shed ensuring the diagonal

trimmed end is at the front. (See diagram on pg 5)

• Rivet the Barge Flashings to the roof and the side wall, using four

rivets on top of barge and four into the side (fig.3).

STEP 5:

• Place the Ridge in position ensuring flashing does not extend past

side wall cladding.

• Rivet Ridge to roof and back wall, riveting at the ends and at each

join of the roof sheets (fig. 4).

STEP 6:

• Place spouting in position and rivet to Barge Flashings at each end

and rivet to roof sheets (1 rivet per 1 sheet) (fig.5).

IMPORTANT

Use 50mm Clouts only on outside ribs covered by Barge flashings and back

wall top plate. Use Roofing Screws on all other ribs. Predrill holes using a

3.5mm drill bit.

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR ROOF PANEL

Assemble as below, making sure that the Clear Roof Sheets overlap the stand-

ard roof sheets on both sides. Pre drill and fasten with the 50mm roofing

screws provided. Ensuring screws are not overtightened as this can damage

the seal and cause the shed to leak.

TOP PLATE

BACK WALL

BOTTOM PLATE

SIDE

WALL

Pan

Barge

X 4

ROOF

SHEET

RIDGE

BACK

WALL

X 5

Spouting

SIDE

WALL

FRONT WALL

fig.1

Rib

fig.2

fig.3

X 5

fig. 4

fig.5