Duratuf MK4A Instrukcja montażu - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Przechowywanie na zewnątrz Duratuf MK4A. Duratuf MK4A 16 stron. Kiwi series, base size 4.210mm x 2545mm

Drukuj stronę

Step 1: Top Door Tracks: Mark the centre of the doorway on

the Overdoor Flashing. Position Centre Door Stop on

the front face of the Overdoor Flashing and up against

the underside of roof. Pre-drill holes and nail in place

with 50mm nails.

Step 3: Hang right hand door in Door Track. At the right

hand end of Door Track, adjust up or down so that

the Door hangs parallel with shed. Fit one rivet at

right hand end to hold in place.

Nut

Washer

Aluminium

Door Stop

Step 5: Clean out ALL drill filings. Also make sure the

Wheels are cleaned of drill filings. Re-hang Doors,

then insert door stops into the pre drilled holes at

end of tracks as shown in diagram. Tighten with

two spanners

Step 6: Bottom Door Guides: Slide Door to corner. Hang Door Guide (A108) on bottom of the Door. Lift up approximately

3mm so that the Door will Slide freely. Pre-drill hole and nail in place using a 50mm nail. Slide to centre. Ensuring Door slides

freely, pre-drill hole and nail Door Guide in place. Check Door is not binding in the middle then pre-drill holes into each Rib at

similar spacing into Door Step Flashing. Nail off using 50mm nails. Repeat with other Door.

Note:

For sheds with Raised Base Plate option the Door Step Flashing will protrude down past the Bottom Plate. Attach Door Guide

with rivets.

MK4A DOORS

Step 4: Position left hand Door Track (C107). Follow Steps 2 and

Door Track

Washer

Bolt

Step 2: Position right hand Door Track (D107) on front wall

up against underside of Roof, with left hand end

hard against the Centre Door Stop. Pre-drill hole in

centre and rivet in place. Remove ALL drill filings

3 to hang left hand Door. Where Door Tracks meet in the

centre, adjust up and down so that the Doors fit snuggly

together, then rivet in place. Remove Doors. Pre-drill

holes into each Rib and at similar spacings into Overdoor

Flashing. At approximately 1/3 in from each end of Door

Tracks put a 50mm nail. Rivet rest of holes.

CLADDING

DOOR

BOT-

PLATE

DOOR

GUID