Duratuf PL46 Instrukcja montażu - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Przechowywanie na zewnątrz Duratuf PL46. Duratuf PL46 16 stron.

Drukuj stronę

ASSEMBLE SIDE PANELS

SELECT:

2 x 1.875 m Side Wall Sheets (Angled)

2 x 1.905 m Side Wall Sheets (Angled)

2 x 1.935 m Side Wall Sheets (Angled)

2 x 1.965 m Side Wall Sheets (Angled)

2 x 2.022 m Top Plates (Red)

2 x 2.020 m Bottom Plates (Green)

96 x 30mm Galv Clouts

12 x Rivets

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface (corner

cutouts to face as shown).

plates are critical to ensure wall panels fit together.

STEP 2:

• Place 1 x 1.875m, 1 x 1.905m, 1 x 1.935m and 1 x 1.965m Side

wall sheets on top of timber plates, with bottom of sheets flush

with each other.

• Rivet sheets together on overlaps as shown.

STEP 3:

• Nail wall sheets to the Top Plate at each end making

sure that the top of the sheets are flush with the top of

the Top Plate and the sides of the wall sheet overhang

the Top Plate by approx 15mm as shown.

• Check that the Top Plate is straight then nail the wall

sheet to the Top Plate, two clouts per pan (see fig. 1).

Standard Shed — Bottom Plate will protrude below

wall sheet by approximately 10mm.

Raised base plate shed — Wall sheet will protrude

below the Bottom Plate by 20mm

STEP 4:

• Nail the wall sheets to the Bottom Plate at each end ensuring each

side of wall sheets overhangs the end of Bottom Plate by 15mm.

Check that the distance between the Top and Bottom Plates is

correct. (As per diagram in step 1)

• Check that the Bottom Plate is straight then nail the wall sheets to

the Bottom Plate, two clouts per pan (see fig. 1).

Repeat with second side panel ensuring Top Plate is as shown.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

Measurements between Top and Bottom

15mm

CLOUT

RIB

PAN

TIMBER PLATE

fig.1

1827mm

1948mm

1827mm

BOTTOM PLATE

RIVET

BOTTOM PLATE

15mm

BOTTOM PLATE

15mm

Second Side

1827mm

Panel

BOTTOM PLATE

1948mm

RIVET

15mm

1948mm

15mm