Duratuf KIWI SHEDS MK2 Instrukcja montażu - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Schronienia Duratuf KIWI SHEDS MK2. Duratuf KIWI SHEDS MK2 16 stron. Base size 2545mm x 1715mm
Drukuj stronę
MK2 CLEAR ROOF PANEL (Optional)
Step 1: Leave a gap where the Clear Panel is to be fitted. Position the next Roof Sheet. Ensure it overlaps correctly, then rivet togeth-
er, one rivet in the centre and one approximately 600 mm down from the centre on both sides. Fit remaining Roof Sheets,
overlapping and riveting as you go. Nail on first Roof Sheet (refer step 3 on page 10).
Step 2: Position clear roof and flat roof sheet (or second clear panel). The flat roof sheet underlaps one sheet and overlaps the other.
The clear roof panel overlaps both roof sheets. Ensure sheet joins are flush at the outside edge then rivet flat sheets to pressed
sheets. Two rivets per join. Centralise roof at the other end and screw in place.
Step 3: Ensure ridge beam is straight, then nail the clear panel and flat roof sheet (or second clear panel) to ridge beam using one
30mm clout per pan. Position on ridge beam and screw in place using six 50mm roofing screws. Screw one 50mm roofing
screw into ridge beam through each rib on overlap, (one screw per sheet). Mould the soft edge on the flashing down into the
pans of the roof sheet to prevent roof leaks.
Step 4: Continue to fasten roof sheets as per step 4 on previous page (pg10)
Note:
When screwing through the clear panel, pre-drill a 6mm hole.
FLAT ROOF
ROOFING SCREWS
30mm CLOUT
RIDGE BEAM
JACK STUD
TOP PLATE
12
RIDGE FLASHING
CLEAR ROOF
PRESSED ROOF SHEET