4-Max SpinRay Instrukcje budowania - Strona 7

Przeglądaj online lub pobierz pdf Instrukcje budowania dla Zabawka 4-Max SpinRay. 4-Max SpinRay 8 stron.

You need to disable the BEC on

one of the ESC's this is done

by removing the red wire and

taping it back out of the way.

Mark the position for the horn

ensuring the holes are over the

hinge line as in the above

photo. Use a 2mm drill to drill

the elevon.

Place a small mark on the side

fin to mark where glue is to be

applied.

This design and all information contained in these building instructions are the © Copyright of 4-Max.

Building Instructions for 4-Max SpinRay

Assemble the wire retainer as

shown above. You will need to

use a 2mm drill to on the horn

for the wire retainer

Spray the horn with kicker and

allow to dry. Apply thick cyano

to the elevon and insert the

horn in the elevon very quickly

and spray with kicker.

Apply UHU Por to side fin and

end of wing (contact glue

4-Max can not responsible for any damage or injury caused by this flying model.

style).

Put a small drop of medium or

thick cyano on the nut and

then spray with kicker. Ensure

that the wire retainer can

rotate easily.

Ensure the servos are centred.

Make sure the servo arm is at

90º to the wing. Trim excess

piano wire with side cutters.

Measure 165mm forward from

the hinge line and insert a

cocktail stick or small piece of

wire through the foam.