APISCALE Wireless digital beekeping scale Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wagi APISCALE Wireless digital beekeping scale. APISCALE Wireless digital beekeping scale 4 stron.

Drukuj stronę

Before placing the scale under the beehive, the scale must be reset to

TARE. We do this by placing the display unit near the scale and

inserting the battery 3V CR123A into the base of the scale. On the

display the number 0,0 show up and the TARE is set.

unit.

2. Trigering pad on the display unit must touch the target on the base

of the scale..

3. As soon as the numbers show up on the display unit we can remove

the display unit and we can take a close look even in an upright

position. Be careful not to block the signal directed to the base. The

weight measured will be confirmed with a three times blinking..

4. Remove the display. The display will automatically shut off after a few

seconds.

Reseting the TARE of the scal must be proccessed everytime the batteries

need changing, at least once a year. To replace the battery in the base of

the scale unscrew the four screws at the bottom of the electronics box.

ERROR MESSAGES:

Battery on the display

unit need to be

changed. Replace it

with CR2032 battery

type.

under the beehive with the display

Battery in the base

unit must be replaced.

Replace it with a

CR123A battery type.

MEASURING

PROCEDURE:

We approach the scale placed

Error has occured.

Unload the scale,

repeat the TARE

process and trigger

the measuring process

again.