4B M100 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria 4B M100. 4B M100 12 stron. Stopswitch stopped motion monitor

O.S.H.A. requires that all exposed rotating shafts are provided with a full guard. Therefore, this device

and its target must be equipped with a guard.

Fasten the M100 to a suitable mounting bracket, such as 4B's Whirligig® universal shaft sensor mount,

with the nose of the switch within the sensing range of the target, as shown below -

All wiring must be In accordance with local and national electrical codes and should be undertaken by an

experienced and qualified electrician.

Use dust/liquid tight flexible metal conduit (when appropriate) with approved fittings to protect the sensor

cables. Use rigid metal conduit to protect the cables from the sensors to the control unit. Conduit systems

can channel water due to ingress and condensation directly to sensors and sensor connections which

over time will adversely affect the performance of the system. As such, the installation of low point conduit

drains is recommended for all sensors.

The M100 has a two wire cable. It must be wired through a load (see below) with the same voltage rating

as the supply being used. The supply polarity to the M100 is not important and the load can be connected

to either wire. The cable can be extended to virtually any length with ordinary 2 wire cable.

Do not wire the M100 directly to a motor starting coil due to the 50 mA maximum current capacity.

CORRECT

Black (N / 0V)

Supply

24 to 240

Volts AC/DC

Blue (L / +V)

WARNING

M100 Shown on Optional Whirligig®

Shaft Sensor Mount with Mag-Con™

Magnetic Connector

STANDARD WIRING DIAGRAM

LOAD