4B P3003V34AI Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria 4B P3003V34AI. 4B P3003V34AI 16 stron. Inductive proximity sensor

1. Check that the unit is correctly installed (see standard wiring diagram).

2. Check that the distance between the target, stud or bolt head and sensing face of P300 is within the

minimum distance specified.

3. Start up machine.

4. If monitoring for speed see A, for proximity monitoring see B -

A. If the P300 is being used to monitor speed, 4B's SpeedMaster™ calibration and testing device

can be used to insure the P300 shuts down the machine at the correct percentage of slip. Shut

down will depend on your specific monitoring setup. 4B recommends an instant shutdown on any

belts slipping 20% or more of normal speed.

B. If the P300 is being used as a proximity switch, be sure that the target is not within range of the

sensor prior to testing. Use a metal putty knife or a small piece of metal and place it between the

sensing face of the P300 and the target. This will cause the sensor to energize the output, and

both the green and red LEDs will go on. Removing the putty knife will de-energize the output

signal and both LEDs will go off.

If the system does not immediately shutdown as expected or alarm as required, then remove the

machine from service until the problem has been diagnosed and corrected.

TESTING AND COMMISSIONING

The SpeedMaster™ with Pulse Pilot is the only device that

accurately tests the calibration of a speed switch, and allows

testing of the alarm and shutdown features of the sensor while

installed on the machine shaft.

The SpeedMaster™ operates in two modes. Input mode is used

to measure the pulse rate at normal speed. Output mode will

allow the user to input pulses to the sensor for testing purposes.

The Pulse Pilot fits between the gap between the sensor and

the target. The Pulse Pilot will have no effect on the operation

Patents -

US8947073

of the speed switch until it is connected to the SpeedMaster™

MX321802

and set to "output" mode.

EP26223568

WARNING

SPEEDMASTER™

PAGE 12