Addonics Technologies MMTPRO Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt komputerowy Addonics Technologies MMTPRO. Addonics Technologies MMTPRO 4 stron. Multi-media tower pro mmtpro
Drukuj stronęWARNING: Please remember to set the power supply to your local outlet
voltage prior to plugging in the power cord. Failure to do so may
damage the power supply.
1. Set the power supply voltage switch to the correct main input voltage, then
connect the power cord to an AC outlet.
2. Turn on the power switch on the back of the unit.
3. Connect the eSATA cable from the eSATA port on the back of the unit to an
eSATA host adapter.
4. Turn on the unit using the power button on the front.
The Multi-Media Tower Pro includes an internal 5x1 Port Multiplier. The unit
must be directly connected to an eSATA host adapter that supports port
multipliers. If the host adapter does not support port multipliers, only the first
device found in the cabinet will be seen by the controller. The unit cannot be
connected to another port multiplier.
The Multi-Media Tower Pro also supports hot swapping for all media types.
This feature must also be supported by the eSATA host adapter. If a drive or
media is inserted or removed when the unit is connected to a host adapter
that does not support hot swapping, the operating system may not reflect the
change at all or it may crash.
Identify your eSATA controller adapter and check with its hardware manufac-
turer if you are unsure if these features are supported. Addonics offers
several port multiplier compatible adapters that also support hot swapping.
Drive Installation: Bay 1 (Snap-In Mobile Rack)
1. Use the key to set the lock to the unlocked position if necessary, then
gently pull the lever.
2. Insert a 3.5" SATA drive or device installed in a Snap-In 25 adapter (not
included), SATA connector first with contacts down. The drive should give
little resistance, DO NOT FORCE IT.
3. Gently close the door over the drive until the drive is completely inserted,
then press firmly until the door snaps closed.
4. Turn the lock to the locked position. The drive will not power up until the
door is locked.
Drive Installation: Bay 2 (Internal Micro SATA UDD)
Gently insert a Micro SATA hard disk or media adapter into the bay, Micro
SATA connector with contacts first, facing down until it resists further travel.
Then press firmly to seat the Micro SATA connector. The drive will be protrud-
ing from the bay.
www.addonics.com
Connecting the Multi-Media Tower Pro
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/