APLICOM A11 Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Rejestratory danych APLICOM A11. APLICOM A11 11 stron.

Drukuj stronę

For replacing the internal battery see document K530003 A11 battery replacement guide available on

•

Aplicom Extranet. DO NOT USE OTHER BATTERIES THAN APLICOM DELIVERED. RISK OF

EXPLOSION.

DISCONNECT ALL CABLES FROM A11 connectors before changing internal battery.

•

Disconnect internal battery by removing the microSIM card if the unit is to be transported by airplane

•

and before long time storage.

INSTALLATION CHECKLIST

Action / Functionality

Device installation

The place of installation is safe from accidental knocks and excessive humidity.

Device is fastened tightly and safely, with no possible interference with vehicle safety

system like Airbag. etc.

Cables

Cables are led carefully along a well-protected route to the device and the peripherals.

All cables are correctly connected and secured with fuses.

Cables are fastened or supported in such a way that during use they exert no torsion

on the connectors.

Antennas

The GPS antenna is fitted in such a way that its visibility to GPS/GLONASS satellites is

best possible and GSM/GPRS antenna has visibility to GSM/GPRS network.

Unit is installed as far away as possible from vehicle radio and its antennas and

wirings.

Make sure that the GPRS sending of the unit does not cause disturbances to car radio

or other vehicle systems.

External antenna cables are led carefully along a well-protected route to the device.

Check that vehicle windows do not have heating system that may block the

GPS/GLONASS signals for example in dashboard or windshield installations.

Check the antenna right orientation towards the GPS/GLONASS satellites and correct

fixing place and surface.

Power on device

Connect PWR and if IGN is used, turn it on.

If movement wake up is used, cause movement to start up the unit.

Final check

Before completing the installation work, rigorous checking of any disturbances

to vehicle or machine, where the unit is installed, must be made. Special

attention is needed to check the vehicle safety systems and radio and

multimedia equipment functions. This is to avoid recalls to service because of

un-noticed problems.

TROUBLE SHOOTING

Problem

Solution

No power

Check that all the cables and fuses are connected.

PWR is connected and IGN is on (if used).

No GPRS connection

Check that SIM card is inserted.

Check PIN CODE requirements.

Check antenna.

Note: The disconnecting of external power cable does not reset the A11 unit.

No GPS position

Check that the GPS/GLONASS antenna has open sky view.

Check interferences from other structures to external GPS antenna if used.

NOTE! Electronic heated or UV-protected windshield may disturb GPS antenna sky view.

If none of the above helps, please contact your equipment dealer for further

assistance.