APlusLift HW-9KBP Instrukcja instalacji i obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy podnoszenia APlusLift HW-9KBP. APlusLift HW-9KBP 17 stron. Baseplate car lift 2-post lift auto hoist
Drukuj stronęCONNECTING POWER UNIT & HYDRAULIC HOSES
•
Using four hex bolts mount the power unit to the main side column.
•
Install 4 inches fitting to cylinder in main side column. Small thread with sealing washer for cylinder. Large thread
for short hydraulic hose. Connect short hydraulic hose to the fitting.
•
Connect short hydraulic hose to the power unit. DO NOT over tighten, as you will crack the fitting.
•
Connect long hydraulic hose between the cylinders and let it lay inside the floor pan. DO NOT over tighten. See
figure 5 for hose layout and routing to the power unit.
INSTALLING SWING ARMS
•
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over the hole in the carriage torsion
tube. Line up the holes and insert the pin. Repeat for the three other arms.
ELECTRICAL CONNECTION
HAVE A QUALIFIED ELECTRICIAN HOOK THE MAIN ELECTRICAL POWER CONNECTION TO THE
POWER UINT ON THE LIFT. FOLLOW LOCAL CODES IN YOUR AREA.
•
The electricity is to be hooked up at the power unit. This is 220 volt single phase power unit. There is one cluster with three
wires out of motor.
•
Yellow/Green is ground wire. Blue is Live 1. Brown is Live 2. (If the 220 volt circuit is from one hot and one neutral,
please wire blue to neutral)
•
The power supply to the lift should be 220 Volt with a 30amp breaker.
•
If wire length less than 10mm, wire size should be 2.5MM2. If wire length more than 10mm wire size should be 4MM2
Figure 4.
10