APlusLift HW-9KOH Instrukcja instalacji i obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy podnoszenia APlusLift HW-9KOH. APlusLift HW-9KOH 17 stron.

•

Maintenance & Safety

MAINTENANCE

Note: IT IS THE CUSTOMER'S OR THE END USER'S RESPONSIBILITY TO MAINTAIN THE PROPER

TENSION ON THE EQUALIZER CABLES. ASKF A QUALIFIED TECHANICAN TO RETURN IN FUTURE

TO MAINTAIN THE CABLE ADJUSTMENT AFTER THE LIFT IS INSTALLED WOULD NOT BE A

WARRANTY FOR THE ADJUSTMENTS.

IF AT ANY TIME YOU'RE NOT SURE TO THE SAFE OPERATION OF THE LIFT, DISCOUNTINUE USING

IT AND CALL YOUR DISTRIBUTOR FOR ASSISTANCE.

Lubrication:

•

Lubricate all Nylon wear block corners inside each column with heavy duty bearing grease before your first operation

and once every six months. Lubricate chains every six months.

Anchor Bolts:

•

During first week of use, check anchor daily. DO NOT use an impact wrench. After first week, check once a month

for the first six months. Tighten if necessary.

Concrete:

•

Check concrete for stress cracks daily for the first two weeks of use as a precaution. Thereafter, check monthly.

Check all bolts and nuts every six months.

Hydraulic Oil:

•

If your lift will raise all the way to the top of the hydraulic tank is full of hydraulic oil. The hydraulic oil should be

changed once a year, along with cleaning the suction filer.

SAFETY LATCH ADJUSTMENT

DO NOT make any adjustment on the lift or cable.

•

If the safety latch in either column does not operate. Use the following procedure to adjust it.

•

Raise the lift until you can see the latch through the access hole in side of the column by removing the plastic cover.

•

DO NOT set lift on safety latch for this adjustment. Allow the hydraulic system to hold the lift during the adjustment.

DO NOT have a vehicle on the lift during this time.

•

Put the latch forward with a screwdriver.

•

If the latch, is not working during descent, loosen the adjustment bolt one full turn and test the latch and follow this

procedure until the latch operates.

•

If the latch is not working during ascent, tighten the adjustment bolt one full turn and test the latch and follow this

procedure until the latch operates.

•

Latch and or cable adjustments are normal maintenance and not warranty items.