Apogee DLX24 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt nagrywający Apogee DLX24. Apogee DLX24 20 stron. Digital loudspeaker controller/system control manager software
Drukuj stronę5. Software Configuration
5.5 Output Processing
4) COMP/LIMIT (Compressor/Limiter)- This is the dynamics processor of the input channel with signal-
peak detection. It has the following controls:
• THRESHOLD- Adjusts the threshold of the COMP/LIMITER (Volts).
• RATIO- Gain reduction of the processed (compressed) signal compared to the incoming signal.
• ATTACK- The time it takes the compressor to start compressing after the threshold has been reached.
• RELEASE- The time the compressor takes to stop compressing after the input signal has fallen below
the threshold.
• MAKE-UP- Gain applied to the signal after compression, to globally increase its level once dynamically
modified.
• KNEE- The type of curve (transition zone around the threshold) that determines whether the bend in the
response curve around threshold is abrupt (HARD) or gradual (SOFT).
• GR (Gain Reduction)- This real-time meter (dB) indicating COMP/LIMIT attenuation, including
MAKE-UP GAIN
5) COMP/LIMIT 2 (Compressor/Limiter)- Dynamics processor of the output channel with signal RMS-level
(Root Mean Square) detection. It has the same controls and indicators as the PEAK Compressor/Limiter.
6) LOUDSPEAKER PRESET- Allows you to load or save a loudspeaker preset for an output channel, on
your computer or on a storage device, which will be directly associated with the characteristics
of a specific speaker system model (crossover frequencies, delay, EQ, compression and limiting, etc.).
This preset can be loaded subsequently in DLX24 devices requiring an
exact copy of the settings it contains. A PROTECTED preset will be
loaded as an uneditable preset. Uneditable setting parameter controls will
be disabled. This will insure that the PROTECTED preset is not edited.
(see Fig. 5-15)
IMPORTANT: When loading a PROTECTED Loudspeaker Preset file, the "AMP GAIN" field must
also be appropriately set. This will ensure proper calibration of the Loudspeaker Preset Limiters.
7) COPY/PASTE- These icons "copy" the settings from one channel and "paste" them in another, cloning
the settings. (All settings, except the label or channel name, can be copied and pasted.)
8) LINK GROUPS- The two inputs can be part of the same LINK GROUP.
In this mode, all the settings of an input (for example, the left channel)
will be automatically applied to the other input (right channel), and vice-
versa. (see Fig. 5-16)
The F2 key gives you access to the Change Channel Name
Screen which allows you to rename an input or output channel.
(see Fig. 5-17)
(cont'd)
10
Fig. 5-15
Fig. 5-16
Fig. 5-17