Apogee Symphony I/O Instrukcje i podręczniki - Strona 7

Przeglądaj online lub pobierz pdf Instrukcje i podręczniki dla Sprzęt nagrywający Apogee Symphony I/O. Apogee Symphony I/O 9 stron.

Apogee Symphony I/O Instrukcje i podręczniki
Pro Tools Native-HD
(using single PCI card- not to be confused with ProTools Native)
✴ Software Release Beta 3.1 or later must be downloaded from Apogeedigital.com and
installed. Following installation restart your computer.
✴ Power off Symphony I/Os
✴ Connect Loop Sync BNC cables to proper connectors in back of unit (Loop Sync Out
on Unit A to Loop Sync In on Unit B and vice versa). Make sure they don't
accidentally connect to the WC connectors!
✴ Connect 1st Symphony I/O to port 1 of Native-HD card.
✴ Connect 2nd Symphony I/O to port 2 of Native-HD card.
✴ Power up units. Set both Symphony I/O's in "Pro Tools HD" Audio Interface Mode
(hold in the right encoders to check and change if you need to)
✴ Launch Maestro 2 (Maestro 2 is Intel Mac only). Go to the "System Setup" tab and
check the checkbox "use Loop Sync" (in some versions of the software, the box is
ALWAYS checked and it's grayed out- this is normal). Also verify that unit A is the
"loop sync master" in the drop-down menu next to the checkbox.
✴ Wait for both units to lock. Unit A should be clocked to Internal displaying "INT" and
Unit B should display "LOOP".
✴ Launch Pro Tools and open the "hardware setup". Click "default" to double-check
that all I/O display.
NOTE: To use Native-HD, you have to use ProTools 9, on G5s, so only Intel Mac-Pros.
© Copyright 2011, Apogee Electronics.
The information in this document is confidential and proprietary. Redistribution without consent is strictly prohibited.
7