Dascom DP-510 Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drukarka Dascom DP-510. Dascom DP-510 19 stron. Thermal printers
Również dla Dascom DP-510: Instrukcje szybkiej konfiguracji (2 strony)

Drukuj stronę

You may find that you can connect the printer to your Personal Computer (PC), and everything works perfectly the

first time. However, there are many variables, and the following guide may help if you find you need some

assistance. These are only suggestions, and may not work with all PC's.

Connecting to a PC – A Checklist

First, MAKE SURE THE PRINTER IS OPERATIONAL

Make sure that the battery pack is connected. Remember that operation from the charger alone is not possible: a

battery pack must always be installed. Also remember that battery packs are normally supplied disconnected

and discharged. They should be connected and then fully charged before use (e.g. trickle charged for at least

15 hours).

Wake the printer up by pressing the Paper Feed button once and releasing it. The Status Indicator should light; if it

does not, the battery may be discharged (or not connected correctly): connect the charger, and the status indicator

will come on.

When the printer is awake, load paper and then press the feed button to check that paper feeds. Press the paper feed

button again twice in quick succession (like double-clicking a PC mouse) and the printer should print a self-test

message. This will show that the printer is operational, and also reports how the printer's serial data interface is

configured.

Next, CONNECT THE PRINTER TO THE PC

The back panel of a PC typically includes several D-type (keystone-shaped) connectors. One of these is usually:

DB-9 Plug (male):

You can use any available serial port for the printer. COM1: is assumed in what follows, as most likely to be

available.

You will need a suitable cable. Use either a standard cable from Dascom (see Section 'Combined Data/Charger

Adaptor Cable'), or make up your own using the information in the same section.

Now you will need to SET UP YOUR COMPUTER'S SERIAL PORT to match the printer (it is also

possible to change the printer's settings, but not until you have established communication with the computer).

Your proposed application program may have a way of doing this, or you can get to the DOS prompt [e.g. C:\>] and

type the following command line (assuming you have connected the printer to COM1:):

MODE COM1:9600,N,8,2 [RETURN]

This will set up the port (COM1:) to 9600 baud, No parity, 8 data bits, and 2 stop bits which is the default setting for

the printer.

Now, SEND SOME DATA TO THE PRINTER from your computer. An easy way to do this from the DOS

prompt is to type:

DIR >COM1: [RETURN]

This should send a directory listing to the printer. The lines will probably overflow, but it will at least show that the

communication between the computer and the printer is working.

Alternatively, in Windows, use the TERMINAL program to send some text to the printer.

™

Windows

Printer Drivers

Getting Started

COM1: Serial port for mouse, modem, serial printer, etc