Dashan DS-350 Instrukcja obsługi - Strona 20
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka Dashan DS-350. Dashan DS-350 20 stron. Strong ventilantion open kerosene heater
Drukuj stronęProblems checking and Electrical
performance
The error code will be displayed on the screen if the heater dose not work
.After the problem is resolved , reset the Run button
No Display
ER01
ER02
ER03
ER05
ER06
ER07
ER08
ER09
ER14
ROF
ROP
KOF
FLOF
KSOF
KSOP
Electrical performance of DS-350ER
Specification:
Forced ventilation, open-end
v a p o r i z a t i o n - t y p e , f o r c e d
Category:
convection
Fuels
lamp oil or kerosene
Fuel Consumption:
Heat:
3.2 or 3.5KW
Fuel tank capacity:
SHANGHAI DASHAN
Resolve the problems
●No power / power plug out
●No tank or not placed flatly
●The heater is tilted or hitted
●Not fired after working for 5 minutes
●Set fire fail
● Detect the flame ignition voltage
when the heater is not fired .
●The cooling time is more than 3
minutes .
●Abnormal combustion of kerosene
●The chimney temperature is too
high
● T h e c o r e t e m p e r a t u r e i s n o t
measured when the heater works .
●The room temperature probe is short
circuit
●The room temperature probe opens
circuit .
●The oven temperature is short
circuit
● The flame probe is short circuit .
●The chimney probe is short circuit
The chimney probe is open circuit
0.08~0.33L/H
●Check the power plug
●Place the fuel tank again .
● Make sure the heater is placed vertically
●Check whether the ignition furnace core is heat
●Check the fuel tank if water on it or not
●Please Check flame probe whether there is dirts .
● If the chimney probe has dirts .
●check whether the kerosene is pure or
not.
●Check whether the room temperature
probe works or not .
●Check whether the furnace core probe
works or not .
●Check whether the room temperature
probe works or not .
●Check whether the oven temperature
works or not
●Check whether the flame probe is dirty or
not
●Check whether the chimney probe is
dirty or not
Rated Voltage
AC220~240V
Frequency:
50~60Hz
Consumption power:
Igniting state:
Working state:
300W
28W