AddSecure Tor V Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Nadajnik AddSecure Tor V. AddSecure Tor V 20 stron. Alarm transmitter

AddSecure Tor V Instrukcja instalacji
1

INTRODUCTION

The Tor V alarm transmitter is connected to an appropriate alarm transmission service, which is
determined by the requirements for the alarm system. The transmitter itself does not need to be
programmed; all the programming is done in the service. Communication depends on the
version of Tor V and the connection: wired by Ethernet and/or wireless over the 2G, 3G, and
4G mobile data network. Communication is encrypted by AES to prevent unauthorized
interception of or tampering with sent messages.
Tor V is constructed to securely transmit fire alarm, intruder alarm, and technical alarm signals.
In addition, Tor V is equipped with a local Ethernet user interface to transmit IP-based
communication from equipment connected locally.
Several service options can be selected for Tor V, all of which contain up to 8 alarm inputs.
Depending on the service, the connection can be monitored with error reporting within 20
seconds.
For the alarm transmitter to meet the requirements of SBF 110:8, the delivered service profile
must also comply with the requirements set forth in EN 54:21, including error reporting within
90/180 seconds (wired connection/wireless connection), and the installation is to follow
specific instructions for the installation of fire alarms. See section 3.1 for all conditions.
For the alarm transmitter to meet the requirements of SSF 114/EN 50136, the delivered service
profile must also comply with the requirements set forth in EN 50136, including error
reporting, and the installation is to follow specific instructions for the installation of alarms. See
section 3.2 for all conditions.
Keep an eye out for these two symbols that are used in this manual.
AddSecure AB
Telefonplan 30
S-126 26 Hägersten
Phone: +46 (0) 8 685 15 00
Web:
http://www.addsecure.com
Every conceivable measure has been taken to ensure the accuracy and completeness of this
documentation. However, as errors can never be fully excluded, we always appreciate any
information or suggestions for improving the documentation.
We wish to point out that the software and hardware terms as well as the trademarks of
companies used and/or mentioned in the present manual are generally protected by trademark
or patent. Some components of the software used in the alarm transmitter are licensed under
GPLv2.
© 2018 by AddSecure AB
All rights reserved.
These two symbols indicate a warning or information to be aware of in
terms of special requirements, exceptions, or other items worthy of noting.
Technical Support
Phone: +46 (0) 8 685 15 50
E-mail:
AddSecure Tor V, PDK-11606
4