AppconWireless RF1276 Series Podręcznik - Strona 15
Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca AppconWireless RF1276 Series. AppconWireless RF1276 Series 16 stron. Lora module
Drukuj stronęFederal Communication Commission Statement
• This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules see Ref. 4. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
SECURITY
– Consult the dealer or an experienced radio/TV technician for help
• OEM integrators instructions
– The OEM integrators are responsible for ensuring that the end-user has no manual
instructions to remove or install module
STATUS
– The module is limited to installation in mobile or fixed applications, according to CFR
47 Part 2.1091(b)
– Separate approval is required for all other operating co nfigurations, including portable
configurations with respect to CFR 47 Part 2.1093 and different antenna configurations
• User guide mandatory statements
– User's instructions of the host device must contain the following statements in addition
to operation instructions:
* "This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation"
* "Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment"
• FCC RF Exposure requirements
– User's instructions of the host device must contain the following instructions in
addition to operation instructions:
Avoid direct contact to the antenna, or keep it to a 20 cm minimum distance while using
this equipment. This device must not be collocated or operating in conjunction with
another antenna or transmitter.
This module has been designed to operate with antennas having a maximum gain of 1
dBi. Antennas having a gain greater than 1 dBi are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms.
FCC end product labelling
The final 'end product' should be labelled in a visible area with the following:
Contains TX FCC ID: 2APJJ-RF1276 to reflect the version of the
module being used inside the product.
Test board infomration:
Model: RF1276
Input: DC5V
Output: DC3.3V
Test mode: Transmitting mode：Low Channel: 902.5MHz/Middle Channel: 915.5MHz/High Channel: 927.5MHz
Applicable FCC rules: 15.249
The modular transmitter is only FCC authorized for the specific rule parts
(i.e., FCC transmitter rules) listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification.