AddSecure IRIS-4 160 Skrócona instrukcja instalacji i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Skrócona instrukcja instalacji i konserwacji dla Terminale dotykowe AddSecure IRIS-4 160. AddSecure IRIS-4 160 11 stron.

Drukuj stronę

IRIS-4 160

Quick Installation and

Maintenance Guide

Once the smartphone, tablet or laptop's Wi-Fi

connects to this network, you will need to enter the

password; check installation notes to see if this has

been changed, the default password is 'password' all

lower case .

Note: If engineers have never used/connected to an

IRIS-4 160 before it may be necessary to download/

install some application software to connect via

the Wi-Fi Web browser, please refer to Section 6.9

"Configuration".

Enter the installer code (should be noted somewhere,

possibly installation notes) and then click Logon .

Engineers will now be in the Main Menu and can

perform the following checks:

7.1. Confirm Current Status

Green SYS LED status is being reported ok go

straight to Section 7 . 2 "Checking battery status" .

Red SYS LED indicates a trouble reported go to the

option for "Trouble report" .

Check the reported system troubles via the

"Trouble report" menu . Please refer to the IRIS-4 160

Engineering Manual for more details available from

http://www . a ddsecure . c om .

7.2. Checking Battery Status

The IRIS-4 160 dialler will indicate any issues with

the batteries . Engineers can check the current battery

status via the "Battery Status" option and confirm

that the Health Status is showing as "Good" before

leaving site .

7.3. Replacing Batteries

If batteries fitted for backup purpose replaced them

every two years .

7.4. Check Software Version/Reflash

Go to the settings menu and then select "Latest

software?" this will then check with the AddSecure

Reflash server if there is a later version available .

If a later version is available, the engineer will see the

option to press the reflash button .

On first entry to the reflash option, which could be

during installation or maintenance, the engineer need

to change the password as required for EN50136-2

compliance . Please record the password on the instal-

lation documentation .

The reflash will take up to 15 minutes if via

4G/3G/2G and approximately 2 minutes with the

Ethernet connection . Once completed the dialler will

reboot and switch to the new software .

Note: All configurations for the IRIS-4 160 dialler

are stored and there is no need to reconfigure.

7.5. Communication Path Checks

The engineers can test the communication paths for

both polling and alarm communications using the

'Connection Test' option in the Main Menu . This

will perform communication path checks for each

path configured . Please refer to the IRIS-4 160

Engineer Manual for more detail available from

http://www . a ddsecure . c om .

IRIS-4 160

7.6. test alarm Panel alarms and

Communication to Monitoring Centre

Depending on the monitoring centre, engineers will

now be required to perform alarm test and possibly

other tests to the Monitoring Centre . Before leaving

site, the engineer should obtain confirmation from

the Monitoring Centre that all is working correctly .