Durite 0-875-15 Instrukcja instalacji i obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Aparat cyfrowy Durite 0-875-15. Durite 0-875-15 14 stron.
Drukuj stronę
LED
Off
Slow blinking
Fast blinking
Solid
LED
Off
Slow blinking
Fast blinking
Alternates from solid to
fast blink every second
Solid
Connect the WiFi dongle to the USB-A socket on the power cable. PosiDon the dongle as high in the
vehicle as is possible, away from any large wiring looms to prevent interference and to ensure the
best chance of connecDvity. Discretely hide the dongle and secure it in place. Electrical tape is usually
employed for this process.
Connect each camera to its respecDve extension cable. Cau8on: ensure that the coloured wires
which join pin match at the pins. The end of the extension cable which connects to the camera is
labelled with a blue tag. Installing the extension cables with the control unit end and camera end
reversed will cause the camera to not funcDon correctly.
Insert the 6-pin connectors on the camera extension cable for each of the cameras you intend to
install (note the "CAM1" and "CAM2" labels). If you are only installing one camera, only use the
"CAM1" connecDon. Then route the extension cables to the opDmum posiDons for the installaDon of
the cameras.
If installing a system with both a visible light and an infrared camera, ensure that they are located
and directed in the desired locaDons (in most installaDons this will be the visible light camera facing
forwards out of the cabin, infrared facing inside the cabin at the driver or passengers). If the
cameras are not labelled as "infrared" or "visible", ask Durite Telema8cs for guidance when the
unit is commissioned. AddiDonally, you should be able to disDnguish between the two when a video
is uploaded: infrared video has a disDncDve pink/magenta Dnt.
Incident Cam | Installation & User Guide
Condition
GPS is off or no power is being provided
The device is attempting to make a GPS
connection
The device is attempting to make a GPS
time synchronisation
GPS is connected and has made a
location fix
Condition
Modem is off or no power is being
provided
Modem is on and is searching for a
connection
Modem is on and a network has been
found
Modem is registered to a network but is
receiving no inbound acknowledgement
Modem is registered to a network and is
receiving acknowledgement ("connected")
5 of 9