Data Harvest EasySense Q 5 Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Rejestratory danych Data Harvest EasySense Q 5. Data Harvest EasySense Q 5 20 stron.

Drukuj stronę

1. What's in the Box

The data set can be downloaded for display and analysis using Collect remote data from

the Collect menu in the Sensing Science Timer program (see the manual that

accompanies the Sensing Science software).

Note: The data is collected as a TIME measurement. For calculating any measurements other

than 'Time and Speed from A to B', the Sensing Science Timer program must be running in

Advanced mode. For the software to be able to calculate the speed, velocity or acceleration, it is

necessary to enter the parameters used i.e. the distance from A to B or the length of the interrupt

card used.

Using EasySense Q connected to a computer for the

first time

Step 1: Install the Sensing Science Laboratory or Primary software

already on your computer. For details of how to install and operate this program, please

refer to the manual that accompanies the Sensing Science software. Make sure

EasySense Q is not connected to the USB port during installation.

Note for existing Sensing Science Primary or Laboratory users: If you have an earlier

version of Sensing Science on your computer, it is best removed before commencing installation

of a later version (i.e. use Add/Remove programs in the Control Panel accessed via

Start/Settings).

Step 2: Install the EasySense Q USB drivers

The first time EasySense Q is attached to a computer the USB drivers will need to be

installed.

Note for Windows 2000 and XP users: You need to be logged on as administrator (or with

equivalent access rights) to install the EasySense Q USB drivers.

Insert the Sensing Science Primary or Laboratory CD ROM into the CD Drive. Cancel

the auto run program.

Connect the 'square' USB plug of the USB communication cable to the USB

compatible input on the side of EasySense Q.

Connect the 'flat'' USB plug to a USB compatible port on your computer.

Windows will automatically detect that a new device has been connected and a

Wizard will be generated to aid installation.

Window 98 users: Select 'Specify a location' and use the Browse button to browse

for the EasySense Q driver folder on the CD and click on OK. Next

Windows 2000 and XP Users: Select to install the software automatically.

Windows XP users: You may be warned that the drivers have not passed Logo

signing, please 'continue anyway' at this point.

When installation is complete, eject the CD ROM and store safely.

Step 3

Check that the LCD screen on EasySense Q is displaying

the main menu. EasySense Q will not communicate with

the PC if it is performing any kind of recording. If the LCD

screen shows samples being taken press the red square

(stop) button and finish the recording.

if it is not

Meter

Snapshot

EasyLog

Timer