Data Industrial 340LW Series Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Nadajnik Data Industrial 340LW Series. Data Industrial 340LW Series 13 stron. Btu transmitter

Drukuj stronę

Programming in Comm Mode

Programming the Model 340LW is accomplished by installing the Data Industrial programming software

on a computer and entering data on templates of the Windows

1. Load the interface software into the computer.

2. Connect the computer to the Series 340 transmitter with the Data Industrial A-301 communications

cable to the socket labeled COMM PORT, taking care to properly align the tab on the plug and

socket to maintain polarity. Connect the DB9 connector of the Data Industrial A301 communications

cable to a PC com port that has the 340 software installed.

3. Move the Protocol Switch to the Comm Mode.

4. Connect the Series 340 transmitter to a power supply.

4. Open the interface software and select the appropriate COMM PORT as shown in the dialog box

below.

5. Open the Parameters Screen as shown below.

To go to the calibration

settings screen select

"parameters" from either

place shown

Data Industrial

Series 340LW Owner's

based program.

Manual