DURKOPP ADLER 867 Dodatkowe instrukcje - Strona 10

Przeglądaj online lub pobierz pdf Dodatkowe instrukcje dla Akcesoria do maszyn do szycia DURKOPP ADLER 867. DURKOPP ADLER 867 18 stron. Remaining thread monitor
Również dla DURKOPP ADLER 867: Instrukcja obsługi (16 strony), Instrukcje (4 strony), Instrukcja obsługi (16 strony), Instrukcja obsługi (8 strony), Dodatkowe instrukcje (20 strony)

4.3 Setting the puller feed operating mode

You can set when the puller should lift up automatically.

1. Open the parameter t 14 00.

2. Set the operating mode:

You can set the number of stitches until the puller is lowered.

1. Open the parameter t 14 03.

2. Set the number of stitches (0-255).

 The puller feed button lights up, the puller feed drive is activated.

You can set the angle at which the puller is to feed.

0° is the reference position here.

The default settings are:

1. Open the parameter t 14 12.

2. Set the initial feed angle (0-359°).

3. Open the parameter t 14 13.

4. Set the final feed angle (0-359°).

Slip properties of various materials can be compensated for.

1. Set a stitch length of 5 mm.

2. Open the parameter t 14 21.

3. Set the material compensation value for the top feed puller (0-255).

4. Open the parameter t 14 31.

5. Set the material compensation value for the bottom feed puller (0-255).

• 0: Puller is not lifted up

• 1: Puller is lifted up with sewing foot aeration

• 2: Puller is lifted with bar

• 3: Puller is lifted with sewing foot aeration and bar

• 10° for the initial feed angle

• 170° for the final feed angle

Additional Instructions 867 - 02.0 - 12/2016

Settings