Cavalli Audio Liquid Fire Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Wzmacniacz Cavalli Audio Liquid Fire. Cavalli Audio Liquid Fire 13 stron.

Your power inlet has been set for the voltage you specified.

1) Insert the power cord.

2) Press the standby switch on the power inlet at the rear of the amplifier. The power switch

on the front panel should light red. The heater and output LEDs should be completely off.

3) Pushing the power switch turns the amp on (see notes below about "The Power Switch").

The amplifier will "awaken" and prepare itself for safe operation in the following sequence

(refer to enclosed diagram):

a) Heaters turn on and the Heater Warm-Up LED glows red -- 20 second delay in

process to protect vacuum tubes.

b) After 20 seconds:

Rail voltages are applied.

ii.

The vacuum tube "heater LED" glows yellow.

iii.

Printed circuit board LEDs light up indicating rail power in circulation.

iv.

The "Headphone Connect LED" glows red. 20 second delay in process to

protect your headphones.

c) After 20 seconds the output delay LED glows yellow, announcing that YOUR CAVALLI

AUDIO LIQUID FIRE HEADPHONE AMPLIFIER IS NOW READY FOR YOUR ENJOYMENT!

Important notes:

 Due to the extreme levels of resolving capability of the Liquid Fire, you will likely notice

changes in the amp's performance in the first half-hour or so after turn on, even after

considerable break in – this is normal. All audio components are subject to this "wake

up" period, though few will demonstrate this phenomenon as acutely as the Liquid Fire.

This is simply another aspect of living with extreme audio performance. Enjoy!

 In order to insure product as well as vacuum tube longevity the power circuitry in your

Liquid Fire headphone amplifier will not let you cycle the power on and off rapidly. If

you turn off the power, the amp will safely recycle through the entire 40 second start

up. This prevents damage that may be caused by sudden changes to and improper

cycling of the power ... or in case of unexpected occurrences like power outages,

accidental power disconnect, etc.

 If your amplifier does not follow this startup sequence or if the output relay LED never

turns yellow, this indicates a problem. Please contact Cavalli Audio customer service at

Page 5 of 12