Datacold 600 T Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe Datacold 600 T. Datacold 600 T 2 stron.

Drukuj stronę
TO ACTIVATE AN ALARM
1.
Press the YELLOW KEY (
) TWICE.
2.
Select the desired compartment by pressing the BLUE Key (
3.
Press the GREEN Key (
) to confirm.
4.
Select by pressing the BLUE Key (
) or the YELLOW Key (
5.
Confirm with "Accept" or "Edit" ( GREEN key
6.
To exit, press the GREEN Key (
)
Remark : If there is an alarm, the acoustic signal will stop after pressing the YELLOW KEY(
input will flash until alarm condition is over.
If Compartment and Alarms settings requested at keypad, please contact your Service Center for
specific configuration.
USER SETTINGS
User setting list
3.1 Time zone offset
UTC±h:min
3.4 Summer / winter time
ON/OFF
3.5 Select language
Setting
3.6 Set display contrast
Setting
3.7 Set display backlight
Setting
3.8 Set buzzer volume
Setting
3.9 Set buzzer frequency
Setting
3.10 Set buzzer on-time
Setting
Display Software version + date +
CTD DC600
time
1. Press the GREEN Key (
) to enter User setting list.
2. Select the desired item by pressing the BLUE Key (
3. Select the desired item by pressing the GREEN Key (
4. Set the parameter needed by using the BLUE Key (
5. Press the GREEN Key (
) to confirm the setting.
6. Press again the GREEN Key (
) to return at default display.
Carrier Transicold Europe PROPRIETARY & CONFIDENTIAL
) or the YELLOW Key (
).
). the desired alarm group: 1, 2, 3 or 4.
).
) . The corresponding
X.XX.X© MM/DD/YY
) or the YELLOW Key (
).
).
) or the YELLOW Key (
).
Feb-15
STATUS DISPLAY
- Press the RED KEY (
). The display mode will change between full information or only showing actual
temperatures enlarged:
T1 T2 T3 T4 T5 T6
DATACOLD 600 recorders are tested and approved to the European EN12830 specification, directives 92/1/EU; 93/43/EU and E-mark
approved following directive 95/54/CE.
TEC_QSG_DataCOLD 600_Rev-_ENG
2/2