Datacolor TF-0022-0961 Skrócona instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Urządzenia przemysłowe Datacolor TF-0022-0961. Datacolor TF-0022-0961 11 stron.

Datacolor AutoLab SPS Quick-start Manual

Step 3:

Make sure target temperature on controller is correct. If not, change it by

following steps 4 to 6.

Step 4:

Press the "SET" button once, the green LED display will flash.

Step 5:

Press up/down button to set target temperature.

Step 6:

Press "SET" again to finish temperature setting.

Step 7:

Check if the hot water tank is full.

Step 8:

Check if the "HEATER ON" button is on. If not, press it to switch it on.

Step 9:

Waiting until the actual temperature is same as target temperature shown

on controller before stating making solution.

Step 10: Start the SPS program to initialize the system.

AutoLab SPS Quick start manual

Actuality degrees

Target degrees

TFSTARTMANSPS / Rev 2.0 / 1st Jul 2013 / Jeffery Fain

Up/Down Button

Page 6 of 11