Datacom Systems VS-1212-F Podręcznik szybkiej instalacji - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik szybkiej instalacji dla Przełącznik Datacom Systems VS-1212-F. Datacom Systems VS-1212-F 17 stron. 10/100/1000 mb and 10 gb data access switches

Drukuj stronę

VS-1212-F and VS-1224-F Data Access Switches

NOTE: For PCs without 9-pin serial ports, check with you product representative for available

sources of a USB to RS-232 Plug-in Adapter.

Step 2. Using a supplied AC Line Cord, plug the VS-1212-F Data Access Switch or VS-1224-F

Data Access Switch into the external power source. Note that either POWER 1 or POWER 2 LED

is illuminated

green

indicating power is available at the rear AC power socket to which the AC Line

Cord is connected. The other POWER LED is illuminated

red

indicating a lack of power to the

unconnected AC power socket. Depress the AC power switch bar icon to power ON the VS-

1212-F or VS-1224-F which is indicated by the internal cooling fans powering up.

Step 3. Open the terminal emulation application on your PC and configure the SERIAL COM

Properties: 115,200 bits per second; 8 data bits; parity none; 1 stop bit and flow control none.

Step 4. Hitting the Enter key twice in a row (i.e., Enter, Enter) establishes a connection, displays

the Command shell prompt, then type ? and press Enter to see a list of available commands.

Step 5. Set the IP address by typing SET IP xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx corresponds

to a valid IP address for your network. Press the Enter key to continue.

Step 6. Set the default gateway (if needed) by typing SET GATEWAY xxx.xxx.xxx.xxx where xxx.

xxx.xxx.xxx corresponds to your network's default gateway. Press the Enter key to continue.

Step 7. Set the subnet mask by typing SET SUBNET xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx

corresponds to your network's subnet mask. Press the Enter key to continue.

Step 8. Type EXIT to save the network address changes and press the Enter key to end the

connection session indicated by 'Connection closed' response.

Step 9. Hit the Enter key twice in succession (i.e., Enter, Enter) to establish another connection

session with the VS-1212-F or VS-1224-F, type SHOW and press the Enter key to review the

network address settings. Verify that the settings are correct.

Step 10. Type EXIT and press the Enter key to end the connection session indicated by

'Connection closed' response. Then close the HyperTerminal window responding 'Yes' to the "You

are currently connect. Are you sure you want to disconnect now?' prompt.