DataComm Electronics 6623 Instrukcja/arkusz instalacyjny - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja/arkusz instalacyjny dla Akcesoria do telewizorów DataComm Electronics 6623. DataComm Electronics 6623 3 stron. In-wall power extension kits

Drukuj stronę

Figure 2: Using the template supplied (see page 3 of instruction sheet), trace the opening for both the top

and bottom plate. See Figure 1 before tracing your opening. Remember, the plates are designed to be

mounted centered between the studs. Using a drywall saw, cut a hole in the drywall the size of each template.

Figure 3: Using a Philips screwdriver, secure male end of the in-wall connector to the female end that is attached

to the top plate using the included metal strain relief and screws.

Figure 4: Run your low voltage cables and the included 14/2 with ground UL approved electrical building wire from

the top opening in the wall through the bottom opening in the wall. You will need to fish the cables from the top

opening to the bottom opening.

Stop: Important: Before installing the top power plate into the top template opening, make sure to pull your low

voltage cables through the low voltage cable opening at the back of the plate.

Figure 5: After inserting your low voltage cables and the electrical building wire through the opening for the top

plate, install the top plate into the wall by inserting the electrical work box into the wall first (see Figure 5).

Slowly slide the top power plate into the opening. Swing the top of the plate into position until the entire plate is

flush against the wall.

Figure 6: Using a Phillips screwdriver, tighten the screws with wings. These wings fasten tightly against the back

of the wall.

Note: Do not overtighten screws.

Figure 7: Pull cables out of bottom opening in the wall. Using a Phillips screwdriver, secure the male end of the in-

wall connector to the female end that is attached to the bottom plate using the included metal strain relief and

screws.

Figure 8: Stop: Important: Before installing the bottom recessed plate with inlet into the bottom template

opening, make sure to pull your low voltage cables through the low voltage cable opening in the back of the plate.

After you have pulled your low voltage and audio/video cables through the bottom power input plate, insert the

side of the plate with the electrical work box into the wall. (see Figure 8). Swing the right side of the plate into

position until the entire plate is flush against the wall. Now tighten the screws with wings. These wings fasten

tightly against the back of the wall. Note: Do not overtighten screws.

Figure 9: Now hang your flat panel TV on the mounting bracket (not included) and plug your TV into the top power

output plate. Then plug your power cord set into the bottom power input plate. Complete installation by plugging

the male end of the power cord set into the nearby wall receptacle.

Figure 1:

Top view - shows needed space between the drywall and the studs. The

power output plate should be centered between the studs.

Page 2 of 3

11/05/2018