Elsat iNode:0x0809 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Elsat iNode:0x0809. Elsat iNode:0x0809 15 stron. Care sensor pht

iNode Care Sensor PHT – instruction manual

3. Battery replacement

The CR2032 battery from iNode Care Sensor PHT should work up to 6 months. So really the

speed of consumption depends on many factors such as operating temperature, frequency of

collaboration with the PC or Smartphone (reading the recorded data), set the transmit power level,

etc. Characteristics of the battery voltage as a function of time is over a long period of time,

practically flat. Only at the end of the battery voltage begins to decrease sharply, and its internal

resistance, which leads to rapid consumption.

In order to replace the battery:

Open the cover:

The iNode cover can be opened without the use of tools. The most comfortable way

to do it like the walnut shell opens. Simply insert into the gap between the two parts

of the casing nails of thumbs and opens it. Inside there is a printed circuit board, with

the metal battery holder.

Remove the circuit board from the enclosure:

The battery is inserted into the holder on the side. It can not be removed if the plate

is located in the housing.

Pull out the holder the old battery.

Insert the new battery:

The battery like a coin has two sides. On one of them there is a large "+" sign and

usually the name of the manufacturer. The other party usually has no markings. Insert

the battery so that the side marked "+" touches with metal handle (it has also the "+"

sign). If the operation was carried out correctly the LED should start flashing.

Insert the circuit board into the housing:

The printed circuit board is not perfectly round has a slight chamfer on one side.

Suits him a little bulge inside the case. By inserting the plate into the housing, pay

attention to these two items were facing each other.

Close the cover:

On one of the parts of the enclosure there is a pin. You need to set it up so that it was

in the vicinity of the beheading described in the previous paragraph. Only with this

setting the cover will close properly

ELSAT s.c.

page 11