Durst M 670 COLOR Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lupy Durst M 670 COLOR. Durst M 670 COLOR 16 stron.

To fit the black-and-white condenser lamphouse on your

Ourst M 670 COlOR, first remove the negative carrier from

the enlarger head and slack off the two milled screws (24)

below the enlarger head (4). Then remove the colour head (1S)

from the enlarger together with the mixing box.

Unscrew the milled screw and remove the blanking plate.

From below insert the lamp holder (9) in the enlarger head

and screw the opal lamp (10) supplied into the lamp holder (23).

Mount the condenser lamphouse over the lower section of

the enlarger head and secure with the two milled screws (24).

Attach the condenser (6) supplied to the condenser lamp

house by engaging the milled screws (2S) in the cutouts on

the condenser housing. Secure the two screws.

Push the negative carrier into the enlarger head and plug

the lead of the enlarger into the socket of an exposure

timer, connecting the latter to the mains supply.

Before enlarging black-and-white films centre the lamp as

described for lamp centering with the Ourst M 670 BW.

Accessories for colour enlargements with the Ourst M 670 BW

If your enlarger is a Ourst M 670 BW and you want to enlarge

your own colour films, you can convert the enlarger to a full

scale colour unit with the separate ClS 670 conversion kit.

This kit consists of:

A colour mixing head

- A TRA 30S transformer or EST 30S voltage stabiliser

- A 100 watt 12 volt tungsten-halogen lamp

- A mixing box for films up to 24

36 mm.

To fit the ClS 670 colour conversion kit on your Ourst M 670

BW, first remove the negative carrier from the enlarger head.

Then slack off the milled screws (24) and remove the

condenser lamphouse (S) from the lower section of the

enlarger head. Unscrew the opal lamp (10) from the lamp

holder (9). slack off the milled screw (29) and pull the lamp

fitting out of the enlarger head. Cover up the lamp opening

by fixing the blanking plate from below so that no light

can emerge when you use the colour mixing head.

Fit the COLAMP 100 S tungsten-halogen lamp (18) in the

colour mixing head (15) so that the lamp is located between its

support (26) and the retaining springs (27) and so that the