Durst M 670 COLOR Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lupy Durst M 670 COLOR. Durst M 670 COLOR 16 stron.

The white-light setting of the Durst M 670 COLOR

To facilitate focusing, the colour filters can be swung out of the

light path with the white-light lever (40). The white-light signal

(47) shows when the filters are swung out. After focusing

swing the filters back into their original position again with

the same lever (40).

Part enlargements

Even expert photographers do not always manage to frame

their picture exactly during the camera exposure. Such

framing or cropping is only possible during enlarging. This

way you can often obtain several interesting enlargements

from one negative or transparency. Adjust the magnification

to bring the required image portion within the masking frame

area on the baseboard.

Giant enlargements

For giant enlargements project on the floor or the wall.

For floor projection unscrew the hexagonal bolts (13) and turn

the column base (3) with the column (2) and the enlarger head

round through 180". Then refit the hexagonal bolts.

Preferably weigh down the baseboard to prevent the enlarger

from tipping over.

For wall projection release the locking knob (22) and turn

the enlarger head (15) through 90" till it engages. Secure the

enlarger head in this position by tightening the locking

knob (22).

Correcting converging verticals

To correct converging verticals release the locking knob (22);

you can now tilt the enlarger head. Tilt the masking frame

with the enlarging paper in the opposite direction. Stop down

the lens sufficiently to obtain an image sharp over the whole

paper area.

Copying

With conversion kits (Order codes VEGAREPRO and

UNIREPRO 670) you can adapt the Durst M 670 SW or Durst

M 670 COlOR for copying.

2 2 - - -