Elsema iS3000 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Otwieracz do bram Elsema iS3000. Elsema iS3000 8 stron. High speed sliding gate opener

Quick Start Instructions

1. Place operator in correct position (Pinion wheel to be parallel to the gate and stepped out

to allow for width of rack once it is mounted onto the gate frame). Mark out fixings and fix

operator to the concrete pad.

2. Fix rack to the gate frame keeping 1mm-2mm clearance between the rack teeth and Pinion

wheel.

3. Once the rack is fixed move the gate and sight the rack moving over the pinion wheel,

check that most of the pinion wheel meshes with the rack. Make sure rack runs freely over

the pinion wheel, any tights spots should be corrected by adjusting the rack height. Check

the operator is firmly bolted down to the concrete pad.

4. Ensure stops are installed on the gate for the fully closed and fully open positions.

Connect Photo Electric Beams, Safety Bump Strip and all other safety devices as required.

Limit Switch Adjustment

Elsema's Industrial motor kits are equipped with dual limit sensors. The 1

and the 2

limit stops the gate. The stop limit in one direction becomes the slow limit in the

opposite direction automatically.

Move the gate into full close position and adjust the magnet on the gate so it aligns with the Stop

limit in the closing direction.

Move the gate into fully open position and adjust the magnet on the gate so it aligns with the Stop

limit in the opening direction.

limit slows the gate