elsner elektronik 70165 Specyfikacje techniczne i instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Specyfikacje techniczne i instrukcje instalacji dla Akcesoria elsner elektronik 70165. elsner elektronik 70165 2 stron. Precipitation sensor
Drukuj stronę
2.4.2. Fitting and connecting the device
3
1
2
1. Slide the device onto the mounting from above.
2. Tighten the screw of the mounting to secure the device.
3. Screw the M8 connector of the connection cable to the connection socket on the
bottom of the device.
Connect the loose end of the connection cable to the KNX bus and auxiliary voltage.
Use the supplied connection box and the terminals.
KNX bus:
+ red
-
black
2.5. Instructions for assembly and initial start-up
After the auxiliary voltage has been applied, the device will enter an initialisation
phase lasting a few seconds. During this phase no information can be received or
sent via the bus.
3.
Addressing the equipment
The equipment is delivered ex works with the bus address 15.15.255. You program
a different address in the ETS by overwriting the address 15.15.255 or teach the de-
vice using the programming button.
The programming button can be reached through the opening on the underside of
the housing; it is recessed by approx. 15 mm. Use a thin object to reach the key, e. g.
a 1.5 mm² wire.
bottom side
top side
1
2
4.
Maintenance
WARNING!
Risk of injury caused by components moved automatically!
The automatic control can start system components and place people
in danger (e.g. moving windows/awnings if a rain/wind alarm has been
triggered while cleaning).
•
Always isolate the device from the mains for servicing and
cleaning.
The device must regularly be checked for dirt twice a year and cleaned if necessary.
In case of severe dirt, the sensor may not work properly anymore.
ATTENTION
The device can be damaged if water penetrates the housing.
•
Do not clean with high pressure cleaners or steam jets.
Precipitation Sensor KNX R sl • Version: 14.04.2020 • Technical changes and errors excepted. • Elsner Elektronik GmbH • Sohlengrund 16 • 75395 Ostelsheim • Germany • www.elsner-elektronik.de • Technical Service: +49 (0) 7033 / 30945-250
Precipitation Sensor KNX R sl
Fig. 7
Auxiliary voltage:
+ yellow
-
white
Fig. 8
1 Programming LED
(under the semi-trans-
parent lid)
2 Programming button
for teaching the de-
vice
2