Dust Right 650 CFM Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odpylacz Dust Right 650 CFM. Dust Right 650 CFM 8 stron. Wall-mount dust collector
Również dla Dust Right 650 CFM: Instrukcja obsługi (8 strony)

Drukuj stronę

Studs

Cleat

Fig. 1

Assembly

1. Attach the Handle (7) to the blower with the two included

1/4"-20 x 1" long Flathead Screws (8).

2. Use four of the included 1/4"-20 x 1/2" long Flanged Hex Head

Screws (9) and the included Hex Wrench (13) to attach the

motor to the black Motor Bracket (3).

3. Use four of the included 1/4"-20 x 1/2" long Flanged Hex

Head Screws (9) and the included Hex Wrench (13) to attach

the black Motor Bracket (3) to the larger black Base (1).

Z-Bracket Mounting on an Exposed-stud Wall

1. Determine where you want to mount your Wall Mount Dust

Collector; installation will be easiest if the location is between

two wooden wall studs.

2. Measure the distance between the two wall studs at the

desired location and cut two lengths of 2 x 4 material matching

that distance. You will mount the Z-Bracket (11) to one of these

cleats; the other will support the bottom of the larger black

Base (1) on the dust collector.

3. Place one of the cleats between the studs at the desired

mounting height, and use a level to make sure it's straight.

Clamp it in place if necessary. Fig. 1.

Cleat

Fig. 2

4. At each end, drill two 1/8" pilot holes through the studs

and into the end of the cleat and drive two #10 x 3"

screws (not included).

5. Attach the second 2 x 4 mounting cleat about 8" down from the

bottom of the first, using the same method. Fig. 1.

6. Position the Z-Bracket (11) on the top cleat as desired, use a

level to make sure it's straight, and use the holes in the bracket

to mark locations for pilot holes.

7. Drill 1/8" x 1

⁄

" deep pilot holes at each location.

8. Secure the Z-Bracket (11) to the top cleat with the

included #10 x 1

⁄

" Wood Screws (12). Fully tighten,

but don't overtighten. Fig. 2.

9. Fit the Dust Right

Wall Mount Dust Collector onto the

Z-Bracket (11), making sure the bracket is between the

left and right limit stoppers. Fig. 2.

Limit

Stopper