Datalogic DLL5000 Series Skrócona instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Skaner Datalogic DLL5000 Series. Datalogic DLL5000 Series 17 stron.

Drukuj stronę
1 DEFAULT
UK
Read the RESTORE DEFAULT.
I
Leggere il codice che ripristina i default.
F
Lecture du code de configuration par défaut.
Lesen Sie den Restore Default Code, um die
D
Werkseinstellung wieder herzustellen.
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
ack/nack disabled, fifo enabled, delay disabled, rx timeout 5
sec., serial trigger lock disabled;
DATA
FORMAT
terminator = CR-LF
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, delays disabled, control
character emulation = ctrl+shift+key;
DATA
FORMAT
terminator = ENTER
PEN EMULATION DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output
level normal, idle level normal, minimum output pulse
600 µs, overflow medium
POWER SAVE
laser driver = off before beep
READING PARAMETERS
trigger type = hardware, trigger signal = level, no timeout,
Flash On = 1 sec, Flash Off = .6 sec, one read per cycle,
safety time .5 sec, beeper intensity high, tone 2

RESTORE DEFAULT

: code identifier disabled, no header,
: code identifier disabled, no header,