CB2 Veer Instrukcja montażu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz CB2 Veer. CB2 Veer 6 stron. Wardrobe
Drukuj stronę
veer
WARDROBE
A
bottom fixed
shelf
B
partition
NOTE: Position
bracket for rod down
when inserting hardware
A. Insert 4 cams into 2 bottom fixed shelves as
shown. Make sure arrows on each cam points
towards nearest edge with holes.
B. Insert 8 wood dowels and 2 cam screws into
partition as shown. Secure, but do not over
tighten, cam screws with a phillips head
1
screwdriver.
A. Fit dowels of right side panel
into corresponding holes of 1 top
and bottom fixed shelves as
shown. Using a screwdriver,
attach top shelf to right side
panel with 2 small bolts, 2 small
spring washers and 2 small flat
washers.
B. Attach bottom shelf to left
side panel, by turning each cam
clockwise until it securely
engages the cam screw.
Repeat steps 3A and 3B for
partition.
NOTE: Do not
over tighten
the bolts
3
Made in Vietnam - r04
NOTE: Make sure arrows on
each cam points towards
nearest edge with holes
NOTE: Do not
over tighten
the cam screws
right side
panel
B
bottom fixed
shelf
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
right side panel
left side panel
Insert 8 wood dowels and 2 cam screws into
2
right and left side panels as shown.
A
small flat washer
small spring washer
A
NOTE: Make sure the
bracket for the rod faces
away from right side panel
during assembly
top fixed
shelf
partition
Page 2 of 6