Dutchess BMIH-9 Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Komercyjny sprzęt spożywczy Dutchess BMIH-9. Dutchess BMIH-9 4 stron. Manual dough divide

Drukuj stronę

D D u u t t c c h h e e s s s s M M o o d d e e l l B B M M I I H H -3 3 6 6 / / 1 1 8 8 M M a a n n u u a a l l D D o o u u g g h h D D i i v v i i d d e e r r

Step 1: Remove the Pan and completely loosen & remove both Black Knobs. (Item 1, Figure 1)

Step 2: Push down on the Trip Lever with your left hand. (Item 2, Figure 1). While holding the Trip

lever down, pull the Operating Handle down with your right hand (Item 3, Figure 2) until the

Head Assembly (Item 4, Figure 2) is about 1/4 inch from the Base (Item 5, Figure 2).

Step 3: Let go of the Trip Lever with your left hand and grasp the Head Assembly (Item 4, Figure

2). Rotate the Head Assembly 1/4 turn until it drops to the Base (Item 5, Figure 2). Raise

the Operating Handle to the full upright position.

Step 4: Grasp the Head Assembly firmly with both hands and remove from the machine. The entire

Head Assembly can now be placed into a sink or dishwasher for cleaning. Hint: For best

results when placing into a dishwasher, extend the blades out of the head and place in dish

tray on its side. Because the Head is round, it must be cradled to prevent it from rolling or

tipping. This can be done using other dishes, bowls or cooking utensils.

Step 5: Wash the Frame of the machine (Item 7, Figure 2) using a damp cloth and mild soap.

Step 6: Place the Head Assembly onto the Base of the machine making sure the rectangular

opening in the top center is lined up in a left to right position as you're facing the machine.

Step 7: Next, push down on Trip Lever with your left hand, (Item 2, Figure 1) and hold. While

holding the Trip lever down, pull the Operating Handle down with your right hand (Item 3,

Figure 1) until the Ram (Item 6, Figure 2) lowers into the opening in the Head Assembly.

You may have to adjust the Head alignment slightly to allow the Ram to fully lower into

the Head.

Step 8: Let go of the Trip Lever from your left hand and grasp the Head Assembly. Rotate the Head

Assembly 1/4 turn until it stops rotating. Raise the Operating Handle to the full upright

position which will lift the Head Assembly off the Base.

Step 9: Replace and tighten the two Black Knobs.

Disassembly Instructions for Cleaning

Reassembly Instructions after Cleaning