Datamax M-Class Mark II Skrócona instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Urządzenie do tworzenia etykiet Datamax M-Class Mark II. Datamax M-Class Mark II 8 stron. Rfid option
Również dla Datamax M-Class Mark II: Podręcznik (6 strony), Podręcznik (8 strony), Skrócona instrukcja obsługi (4 strony), Podręcznik (10 strony), Skrócona instrukcja obsługi (6 strony), Skrócona instrukcja obsługi (8 strony)

Setup and Configuration (display models)

In order to use thermal transfer printing the 'Media Type' menu function must be set to 'Ribbon

Transfer'. Follow the steps below to set the printer to 'Thermal Transfer'.



Note:

The DMXConfig Utility can also be used to change the Media Type setting. For more

information see the previous section "Setup and Configuration (non-display models)"



Note:

During this procedure, consult the Operator's Manual for detailed front panel instructions.

Configure the printer for the thermal transfer use as follows:

 Plug the power cord into the AC Receptacle and turn 'On' the Power Switch.

 Press the MENU Button on the printer's front panel.

 Press the ENTER Key to select MEDIA SETTINGS, and press the key again to select MEDIA TYPE.

 Using the DOWN Button, scroll to THERMAL TRANSFER then press the ENTER Key.

 Press the EXIT Key and then, at the SAVE CHANGES? prompt, press the YES Key.

Unloading the Thermal Transfer Assembly

When the ribbon supply has been emptied, simply pull the cardboard core off the Supply Hub. To remove

the used ribbon, grasp the ribbon and pull it from the Take-Up Hub.