Datapath VSN1100X Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Podwozie Datapath VSN1100X. Datapath VSN1100X 20 stron. Expansion chassis

Connecting a VSN900X Expansion Chassis

If your expansion chassis is supplied as part of a wall controller system the HLink-G3 card will be

pre-installed in the host machine which contains the SBC. If the expansion chassis has been

supplied separate to a host machine the HLink-G3 card provided needs to be installed in the host PC.

You are likely to need a flat blade and/or a cross head screwdriver for the installation of the HLink-G3 card;

it would be useful to have these to hand before you begin. Power down the PC (including peripherals),

switch off at the mains and disconnect all the cables connected to the computer and expansion chassis.

Remove the PC cover. Locate a vacant PCIe slot (x8 on the motherboard and remove the backing plate

(retain all screws) .

Remove the HLink-G3 card from its packaging and secure it firmly into the empty PCIe slot. Screw the

bracket to the back panel of the PC and replace the cover.

Connect the HLink-G3 and SLink-G3 using the ExCable-G3 provided. If more than one expansion chassis is

supplied, ensure the cards are paired correctly by connecting the cards labelled "Link1" together, the pair

labelled "link2" are connected together and so on. In the event that this is not possible i.e. the expansion

chassis are shipped separately and the cards are not labelled, connect the cards using the ExCables-G3

provided and re-install the Datapath Driver Install package to reset the pairings.

ExCable-G3

HLink-G3

SLink-G3

SBC

Main Chassis

Host PC with a single VSN900X expansion chassis providing up to 17 PCI Express slots

ExCable-G3

HLink-G3

SBC

SLink-G3

Main Chassis

Host PC with two VSN900X expansion chassis providing up to 25 PCI Express slots